THE PHYSICO-CHEMICAL PROPERTIES OF SOME FINE AGGREGATES IN LOKOJA, NIGERIA

Authors

  • Samuel L Akingbonmire Department of Civil and Environmental Engineering, Federal University of Technology, Akure, Nigeria
  • L Samuel Department of Civil and Environmental Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
  • O Oluwafemi Omotayo Department of Civil and Environmental Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
  • J O Afolayan Department of Civil and Environmental Engineering, Federal University of Technology, Akure, Ondo State, Nigeria
  • A Banjo Olorunshola Department of Civil and Environmental Engineering, Federal University of Technology, Akure, Ondo State, Nigeria

Keywords:

Concrete, fine aggregates, physical and chemical properties

Abstract

Fine aggregates, as one of the major components of concrete, play a major role in determining the quality of concrete to be produced, hence the need to know its physical and chemical properties. Disturbed soil samples were obtained from ten different construction sites in Lokoja, Nigeria. The samples were analysed for their physical properties such as moisture content, silt and clay content, organic content, density, specific gravity and particle size distribution, and their chemical properties. The results obtained showed that samples 3, 4, 5 and 9 had the highest specific gravity of 2.63 while samples 1, 2 and 7 had the least specific gravity of 2.83. However, the silt and clay contents were also significantly high for samples 1, 2, 5, 9 and 10 which have their values greater than 7% indicating that the samples need to be washed before use for adequate integrity of the concrete as stipulated by ASTM 0C33 of 1994. It was also observed from the analysis that almost all the samples were poorly graded, with samples 5, 9 and 10 having significantly better gradation than the others. On the basis of the values of porosity, void ratio and unit weight, majority of the samples could be classified as uniform fine sand or coarse sand. Meanwhile, the result of the chemical analysis showed that sample 4 has the highest composition of Ca2+ (356 mg/kg) while sample 3 has the highest composition of Cl-1 (1.6 mg/kg). However, majority of the samples could be susceptible to alkali-aggregate reactions when used in concrete production hence the need for alkali-silica reaction suppressants such as fly-ash, silica fumes and lithium compounds.

References

Abdullahi, M. (2006). Properties of Some Natural Fine Aggregates in Minna, Nigeria and Environs. Leonardo Journal of Sciences, 8, pp.1-6.
ASTM C33, (1994). Standard Specification for Concrete Aggregates. Annual Book of ASTM Standards, 4.
ASTM D2487, (2006). Standard Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System). Annual Book of ASTM Standards, 04(08).
Camlab (2017). Laboratory Equipment: PFP7 Flame Photometers. https://www.camlab.co.uk/pfp7-flame-photometers-p12826.aspx. Date accessed: 3rd July, 2017.
Farny, J. A., & Kerkhoff, B. (2007). Concrete Technology, Diagnosis and Control of Alkali-Aggregate Reactions in Concrete. Portland Cement Association (PCA), pp.1-26.
Garg, S. K. (2005). Soil Mechanics and Foundation Engineering. Khanna Publishers, Delhi, India.
Hover, K. (2013). Observed Variability in Tests of Fresh Concrete Properties from the FHWA Highway Materials Engineering Course. Transportation Research Record: Journal of the Transportation Research Board (2342), pp.61-75.
Hyodo, H., Tanimura, M., Sato, R., & Kawai, K. (2013). Evaluation Of Effect Of Aggregate Properties On Drying Shrinkage Of Concrete. Paper presented at the Third International Conference on Sustainable Construction Materials and Technologies, Kyoto, Japan, pp.1-8.
Kosmatka, S. H., Panarese, W. C., & Kerkhoff, B. (2002). Design and control of concrete mixtures (Vol. 5420): Portland Cement Association Skokie, IL.
Lane, D.S., (2002). Laboratory Investigation of Lithium-Bearing Compounds for Use in Concrete, VTRC 02-R16, Virginia Transportation Research Council, Charlottesville, Virginia, pp.1-18.
Langer, W. H., & Knepper, D. H. J. (1995). Geologic Characterization of Natural Aggregate; A field Geologist's Guide to Natural Aggregate Resource Assessment. U. S. Geological Survey, U. S. Department of Interior, Denver, USA, pp.1-2.
Neville, A. M. (2011). Properties of Concrete (Fifth Ed.). Pearson Education Limited, England, pp.506-520.
Owsiak, Z., & Zapała-Sławeta, J. (2013). The course of the alkali-aggregate reaction in the presence of lithium nitrate. Ceramics–Silikáty, 57(2), pp.138-145.
Page, C. L., & Page, M. M. (2007). Durability of concrete and cement composites. Woodhead Publishing Ltd, Cambridge, England, p.248.
Rached, M. M., De Moya, M., & Fowler, D. W. (2009). Utilizing aggregates characteristics to minimize cement content in portland cement concrete. International Center for Aggregates Research (ICAR). National Technical Information Service. Springfield, Virginia, pp.1-2.
Schuman, D. C., Carrasquillo, R. L., & Farbiarz, J. (1988). State of the Art Report on the Mechanism of Alkali-Aggregate Reaction in Concrete Containing Fly Ash. Center for Transportation Research, The University of Texas at Austin; Austin, Texas, pp.9-43.
Xu, H., (1987). “On the Alkali Content of Cement in AAR,” in Concrete Alkali-Aggregate Reactions, Proceedings of the 7th International Conference, edited by Grattan-Bellew, Patrick E., Noyes Publications, Park Ridge, New Jersey, pp. 451-455.

 
Futajeet Vol. 12 Issue 2

Downloads

Published

2019-04-28

Issue

Vol. 12 No. 2 (2018): FUTA Journal of Engineering and Engineering Technology

Section

Articles

License

Copyright

With the submission of a manuscript, the corresponding author confirms that the manuscript is not under consideration by another journal. With the acceptance of a manuscript, the Journal reserves the exclusive right of publication and dissemination of the information contained in the article. The veracity of the paper and all the claims therein is solely the opinion of the authors not the journal.